No results were found for the filter!
Diamond Hollow Drills for Ceramic
BO 79.4605
Developed especially for the Bohle Aqua Drill wet drilling machine · manual drill bit exchange without tools · for drilling hard ceramic tiles, granite, marble and regular tiles Belgian thread 1/2" Speed ranges: 0 - 400 rpm – ø40 to...
Diamond Countersinks, Industrial Quality
BO 5001570
The optimized spiral form follows function - means inside sintered 6mm thick diamond section are spiral form slots for coolant water and glass abrasion sludge. Outer thread (Continental) R 1/2"
Victory diamond countersink
BO 5001550E
Diamond countersink Ø 15/50 mm, slotted/5 section, industrial standard, 1/2" connection thread Outer thread (Continental) R 1/2"
Diamond Core Drills with Deep Countersink, Industrial...
BO 5001806
The quality demands placed on deeply countersunk bores in combination with shorter cycle times per countersink have continually grown, particularly in the fields of facade construction and interior fit-out. Bohle has now brought its...
Segmental Diamond Drills
BO 5004100
Adjustable · with exchangeable segments · central bore hole for coolant supply Connection thread (Continental) R 1/2"
Diamond Countersinks, Industrial Quality
BO 5001520
Other diameters on request Outer thread (Continental) R 1/2"
Grinding Cone Holder
BO 79.610
Elastic Vulkozell® body · transverse slits for attaching and exchanging the grinding cones BO 79.6120 (ø60 mm) / BO 79.9120 (ø90 mm) · Made in Germany Shaft ø 6 mm
Grinding Cone
BO 79.6120
The grinding cone is used to arris drilled holes and cut-outs in glass or similar materials such as ceramic or stone. It can be used on machines suitable for wet working, e.g. cordless drivers or pneumatic power drills, which rotate...
Diamond Core Drills with Countersink, Industrial Quality
BO 5001605
For the highest requirements · high drilling capacity and service life · drill base made of stainless steel · diamond coating from sintered material · with slots for better cooling · pre-sharpened, ready-to-use · special dimensions on...
Diamond Core Drill with Countersink, Standard Quality
BO 5000604
For normal use · drill base made of steel · covered with protective lacquer · diamond coating from sintered material · countersink is fixed by lateral clamping screw · drill has to be sharpened before first use. Outer thread...
Set of Diamond Hollow Drills for Ceramic
BO 79.361
With one ceramic diamond hollow drill each with diameters of 6, 8, 10 and 12 mm · drill core ejector and pin for releasing tight drills
Sharpening Stone for Diamond Drills
BO 5000499
By drilling powerfully into the sharpening stone a few times, new spaces are created between the diamond particles, leading to renewed cutting ability · if sharpening does not lead to a positive result, use the dressing stone first...
Recently viewed