Fixing and mounting without drilling - the universally applicable suction holder offers many application possibilities. The Ø 6.5 mm hole allows the use of additional attachments. For this purpose, this version is equipped with stainless steel components.
The tilting lever, which can be adjusted by 90 degrees in two directions, allows the width of the suction holder to be ideally adapted to the desired application. The softer rubber pad is used to achieve a longer holding time. Furthermore, this enables the suction holder to hold not only on flat, gas-tight surfaces, but also on slightly structured ones. The specially designed and produced Veribor® rubber pads achieve a tested torque of 16 Nm.
Application note: