The 150 mm rubber pad of these universally applicable suction mounts allows them to be fixed and attached to more curved and slightly textured surfaces. The additional 6.5 mm hole allows the use of suitable screws.
The toggle lever, which can be adjusted by 90 degrees in two directions, allows the width of the suction holder to be ideally adapted to the desired application. The large rubber pad is equipped with a release tab so that it can be easily removed from the substrate. The specially designed and produced Veribor® rubber pads achieve a tested torque of 16 Nm.
Application note:
A twofold safety factor was taken into account for all load-bearing capacity data. The tests to determine the load capacity were carried out on glass. Please take into account that the load capacity may vary depending on the area of application.