Fixing and mounting without drilling - the universally applicable suction holder offers many application possibilities. The Ø 6.5 mm hole allows the use of plugged extensions. This version also has a sealing lip rubber pad for structural surfaces.
The toggle lever, which can be adjusted by 90 degrees in two directions, allows the width of the suction holder to be ideally adapted to the desired application. The softer rubber pad is used to achieve a longer holding time. Furthermore, this enables the suction holder to hold not only on flat, gas-tight surfaces, but also on slightly structured ones. This is further enhanced in this version by the sealing lip rubber pad, as the circumferential sealing lip can seal light to more pronounced structures. The specially designed and produced Veribor® rubber pads achieve a tested torque of 16 Nm.
Application note: